under operation with ultra clear and precise dot indication at different work distances, it would never be a challenge job for users until selecting a quite practically used device, such as a 635nm red dot laser module. it emits at least 3 times brighter red laser light than formal 650nm red laser with the same output power. once it gets proper installation and adjustment to correct position, without any limitation by long distance, high height and complex working environments, this 650nm red laser alignment just brings users quite satisfied dot measurement for all application fields effectively.
the basis use of a 635nm red dot laser module is always working for a quite long time, thus it is a major part to maintain its stable and reliable dot indication onto different working surfaces. the unique use of an import 635nm red laser diode has just assured increasing laser beam stability of at least 40%. in process of long lasting red dot indication work, after leaving enough time and space for tube cooling down, this direct diode made 650nm red laser alignment obtains long lasting red dot projection within 10 hours, and still maintains up to 85% laser beam stability in proper use.
according to a series of strict laser beam stability test and aging preventing test up to 24 hours, usually the real use of a 635nm red dot laser module obtains high level of laser light cycling use, and long lasting red dot projection. employed by a qualified glass coated lens, even though it is pointing at quite long work distance, this alignment laser still maintains its stable red dot projection, and perfect protection of itself from overheating, over current impact as well.
when 635nm red dot laser module applies apc, acc driving circuit board, available with wide range output power of 5mw to 100mw, it still maintains long lasting red laser beam and red dot indication. it gets perfect protection of itself from increasing temperature and serious electric current impact as well. for the most important of all, when red alignment laser gets the use of high power up to 50mw to 100mw, users should pay high attention to thermal energy hurt to eyes and wear correct laser safety goggles, it just brings users easy, no danger and low cost dot generation for all working occasions.
